56
Installing and Removing the Infant Car Seat
Installing without Base Using Lap/Shoulder Belts (Preferred Method)
5. Push Infant Car Seat rmly into vehicle
seat, pressing down near the child's legs
A, while pulling up on the SHOULDER
PORTION of the vehicle seat belt B to
remove slack from the LAP PORTION.
6. Make sure that vehicle belt buckle and
hardware DO NOT INTERFERE with the
Infant Car Seat.
7. Check the recline angle. Adjust the
seat angle until the BLUE LEVEL LINE
on the Infant Car Seat is level with the
ground. A tightly rolled towel or pool
noodle may be placed under the Infant
Car Seat, near the vehicle seat back, to
adjust the angle, if necessary.
u
t
y
Front of Vehicle
Line must be level with ground when
installed without Base.
A
B
To Next Page
Loading...
