Install top steps
1. Install right top step by placing in position and inserting a long 3/8” drive socket extension into top
step.
Qty.DescriptionItem
1
3/8” Drive Socket Exten-
sion
1
1Right Top Step2
2. Pry the long 3/8” drive socket extension forwards to secure right top step.
3. Repeat steps 1 and 2 for left top step.
Install end caps
1. Install two screws securing right end cap using a Phillips screwdriver.
Qty.DescriptionItem
2Screws1
1Right end cap2
2. Repeat step for left end cap.
Center and tension the running belt
1. Plug the power cord into the power outlet.
2. Turn the main power switch to the on (I) position.
3. Tap the Quick Start icon.
4. Press the Speed + key to bring the speed up to 5 mph (8 kph). Allow the treadmill to run for a minute.
The lateral position of the running belt is correctly centered when the Cybex logo is centered between
the inside edges of the two belt tracking slots. If the Cybex logo is not centered between the belt
tracking slots, center the running belt with the following procedure.
Page 134 of 209
Cybex 625T Treadmill Part Number
To Next Page
Loading...
