CYBEX 625T Service Manual

Audio Visual Configuration
Audio Visual is available in three configurations: Shared TV's, Personal TV on a stand, or TV embedded
in product.
Perform the following procedures to complete the audio visual setup.
• Assemble product.
• Determine audio visual configuration.
• Configure product for one of the three configurations.
• Install and setup audio visual components.
Determine Audio Visual Configuration
Determine which audio visual configuration you have.
Embedded TV setupPersonal TV setupShared TV setup
TV embedded in product. The
product uses the E3 View Monitor.
Personal TV on a stand. TV is
controlled with a C.A.B. (Console
Adapter Box) or C-tv (Connected
TV) connect to the product.
Shared TV's on wall or hanging
from ceiling. Audio is sent to
product via wireless transmitter.
See Embedded TV SetupSee Personal TV SetupSee Shared TV Setup
A/V setup mode
Falling hazard. When starting unit
• Stand on two top steps.
• Do not stand on belt.
1. Plug the power cord into a power outlet from a grounded, dedicated circuit as described under
Electrical Requirements in this chapter.
Do not stand on treadmill during this procedure.
2. Ensure the power cord is not being pinched under the front of the treadmill.
3. Toggle the power switch on (|).
Power switch is located under the front end of the treadmill. The control panel will lightup and be in
the Dormant Mode.
Page 31 of 209
Cybex 625T Treadmill Part Number

CYBEX 625T Specifications

General

User Weight Capacity	400 lbs
Speed Range	0.5 - 12.4 mph
Incline Range	0% to 15%
Display	LED
Heart Rate Monitoring	Contact and wireless
Running Area	60" x 20" (152 x 51 cm)