CYBEX 625T - Page 151

Remove end caps
1. Remove two screws securing right end cap using a Phillips screwdriver.
Qty.DescriptionItem
2Screws1
1Right end cap2
2. Repeat step for left end cap.
Remove top steps
1. Remove the right top step by inserting a long 3/8” drive socket extension into the right top step and
prying backwards.
Qty.DescriptionItem
1
3/8” Drive Socket Exten-
sion
1
1Right Top Step2
2. Remove right top step.
3. Repeat steps 1 and 2 for left top step.
Loosen rear roller
Loosen the rear roller mounting bolts using a 3/4” Socket wrench.
Loosen front roller
Loosen the front roller mounting bolts using a 9/16” Socket wrench.
Remove drive belt
Remove the drive belt off of the drive motor pulley.
Page 151 of 209
Cybex 625T Treadmill Part Number