Tighten front roller
1. Install the drive belt onto the front roller.
Qty.DescriptionItem
1Front Roller Pulley1
1Drive belt2
1Drive Motor Pulley3
2. Ensure that the drive belt is aligned properly in the grooves on the drive motor pulley and front roller
pulley. The drive belt should be positioned in the inner most groove of the drive motor pulley.
Tighten rear roller
1. Tighten the two rear roller bolts using a 3/4” Socket wrench.
Tighten each bolt evenly, making sure not to tighten either bolt too many turns before moving to the
other bolt.
2. Continue to tighten bolts until the front roller is all the way back in the tensioning slots.
3. Tighten the front roller bolts using a 9/16” Socket wrench.
Install top steps
1. Install right top step by placing in position and inserting a long 3/8” drive socket extension into top
step.
Qty.DescriptionItem
1
3/8” Drive Socket Exten-
sion
1
1Right Top Step2
2. Pry the long 3/8” drive socket extension forwards to secure right top step.
3. Repeat steps 1 and 2 for left top step.
Page 155 of 209
Cybex 625T Treadmill Part Number
To Next Page
Loading...
