Remove power cord
1. Remove the mounting screw securing the mounting bracket in place using a Phillips screwdriver.
Qty.DescriptionItem
1Power Cord1
1Power Cord Inlet2
1Mounting Bracket3
1Mounting Screw4
2. Unplug the power cord from the power cord inlet.
Power cord may be routed through frame. See Owner’s manual.
Install power cord
1. Plug the power cord into the power cord inlet.
Qty.DescriptionItem
1Power Cord1
1Power Cord Inlet2
1Mounting Bracket3
1Mounting Screw4
2. Install the power cord with the mounting screw and mounting bracket using a Phillips screwdriver.
Complete installation
1. Plug the power cord into the power outlet.
2. Verify the power cord is not being pinched under the front of the treadmill.
3. Operate the unit at all levels to verify proper operation.
On/Off Switch
Tools Required:
• Phillips screwdriver
• Flat head screwdriver
Disconnect power source
1. Toggle the on/off (I/O) power switch to the off (O) position. The on/off (I/O) power switch is located
under the front end of the unit, or on the front right side panel.
Page 163 of 209
Cybex 625T Treadmill Part Number
To Next Page
Loading...
