2. Connect the two white fast-on connectors to the on/off switch.
Qty.DescriptionItem
1To power inlet (White)1
1To power inlet (Black)2
1On/Off switch3
1To line filter (Black)4
1To power supply (Brown)5
1To power supply (Blue)6
1To line filter (White)7
1
Position On/Off switch as
shown
8
3. Connect the two black fast-on connectors to the on/off switch.
4. Connect the brown and blue fast-on connectors to the on/off switch.
Install motor cover
1. Place the motor cover into position vertically by aligning the two tabs and four plastic connectors.
Two plastic connectors are mounted in the front cover and two in the motor cover. If motor cover
top does not fit properly, loosen the side screws as needed.
Qty.DescriptionItem
1Motor Cover1
1Front Cover2
2Screws3
4Plastic Connectors4
2. Tighten the two front cover screws using a Phillips screwdriver.
Be sure the screws are securing the motor cover's tabs.
Complete installation
1. Plug the power cord into the power outlet.
2. Verify the power cord is not being pinched under the front of the treadmill.
Page 166 of 209
Cybex 625T Treadmill Part Number
To Next Page
Loading...
