2. Remove motor cover by carefully lifting vertically. Do not break the four plastic connectors.
Disconnect incline motor cable
1. Remove the ground wire screw securing the ground wire using a Phillips screwdriver.
Qty.DescriptionItem
1Motor Controller Connector1
1Incline Motor Cable2
1Ground Wire Screw3
1Ground Wire4
2. Disconnect the incline motor cable by un-latching the connector from the motor controller connector.
Remove elevation motor
Older models use bolts, sleeves, and nuts to secure the tube nut. If used, these will be discarded and
replaced with shafts and retaining rings. Use a 9/16" Open end wrench and a 9/16" socket wrench for
removal.
1. Remove a retaining ring from the tube nut shaft using a flat head screwdriver.
Qty.DescriptionItem
4Retaining ring1
1Tube nut shaft2
1Tube nut3
1Tube nut mounts4
1Motor mount shaft5
1Sleeve6
1Elevation motor7
1Frame mounts8
2. Slide the shaft out of the tube nut mounts.
3. Remove a retaining ring from the motor mount shaft using a flat head screwdriver.
Hold the motor while you remove the shaft so that the motor doesn't fall.
Page 175 of 209
Cybex 625T Treadmill Part Number
To Next Page
Loading...
