Install handset assembly
1. Place handset assembly in position and plug in the following cables: contact heart rate grips (J7),
handset membrane (J9) and the ground wire.
Qty.DescriptionItem
1Handset membrane (J9)1
1Contact heart rate grips (J7)2
2. Install eight screws securing handset assembly to console using a Phillips screwdriver.
Qty.DescriptionItem
1Handset assembly1
1Console2
8Screw3
Complete installation
1. Plug the power cord into the power outlet.
2. Verify the power cord is not being pinched under the front of the treadmill.
3. Operate the unit at all levels to verify proper operation.
Contact Heart Rate Grips
Tools Required:
• Phillips screwdriver
• Needle nose pliers
• ESD (Electrostatic Discharge) grounding strap
Page 189 of 209
Cybex 625T Treadmill Part Number
To Next Page
Loading...
