CYBEX 625T Service Manual

Error 15: Embedded A/V Device Failure
Cause:
A software task has failed, causing a delay in the routine running of the code on the Graphics Board. If
the delay is long enough, a hardware timer in the processor will re-boot the processor. When the
processor comes up, it will communicate what caused the reset (watchdog vs. normal power reset.)
Watchdog resets are logged as Error 12. Power resets are not logged.
Service:
Check the cables and connections required between the MCC and the A/V device. If cabling appears
normal:
• For an embedded wireless receiver, replace the receiver and all cabling.
• For an embedded PEM, verifiy the EPEM works with the remote control and/or swap the EPEM with
a known working PEM or on to another unit to see where the problem lies.
Page 82 of 209
Cybex 625T Treadmill Part Number

CYBEX 625T Specifications

General

User Weight Capacity	400 lbs
Speed Range	0.5 - 12.4 mph
Incline Range	0% to 15%
Display	LED
Heart Rate Monitoring	Contact and wireless
Running Area	60" x 20" (152 x 51 cm)