CYBEX 625T Service Manual

Error 95: Low Voltage (DC Link)
Cause:
Input voltage drops to unacceptable limits:
• <200V for the 230V unit
• <85V for the 115V unit
Service:
Error 95 is caused by a power outage while the belt is moving, either on purpose (running the treadmill
to incline it, then shutting it off with the power switch) or by an outside influence (plug was kicked, loose
fitting outlet, power outage, circuit breaker tripped, or simply shutting of the power at the breaker).
• Verify the input voltage is correct for the controller used.
• Monitor input voltage for brown-outs and sags.
• Make sure the treadmill is on a dedicated circuit.
More than likely, power was interrupted during use and the treadmill itself has nothing wrong with it.
Page 91 of 209
Cybex 625T Treadmill Part Number

CYBEX 625T Specifications

General

User Weight Capacity	400 lbs
Speed Range	0.5 - 12.4 mph
Incline Range	0% to 15%
Display	LED
Heart Rate Monitoring	Contact and wireless
Running Area	60" x 20" (152 x 51 cm)