B. Using the hex key provided, tighten the two pivot screws on the handrail. See Figure
9.
9. Remove the left side panel.
A. Pull the left side panel away from the base. See Figure 10.
10. Arrange power cord.
A. Decide whether you will plug the power cord into an outlet near the front of the
treadmill or the back of the treadmill. Follow the corresponding routing procedure
below. NOTE: Do not plug in the power cord at this time.
Cybex TROTTER Elite Treadmill Owner’s & Service Manual
Figure 10
Left Side Panel
Figure 8
Pivot
Screws
Figure 9
3
Setup
&
Assembly
Page 5-7
To Next Page
Loading...
