Safety Sentry — This is how long the running belt will keep moving if the user steps off
the treadmill. Choices are between none seconds and 1 minute. Default is 20 seconds.
Choosing “none” will disable this feature. NOTE: See Safety Sentry in chapter 3 for more
details about.
Remember: You must press Enter after changing a value for that value to be stored.
3. To exit Test Mode press the Stop key twice.
Your treadmill is now ready for use. Follow the instructions in the Operation chapter to learn how to
operate the treadmill. You should begin with walking speeds first, to be sure everything is
functioning properly.
Cybex TROTTER Elite Treadmill Owner’s & Service Manual
Setup
&
Assembly
Page 5-13
To Next Page
Loading...
