.
25
.
Cold motorcycle startup and preheating steps are as
follows:
1. Turn on the ignition lock, wait for the fuel pump to
run for several seconds and stop, and check whether the
instrument indicator light of the motorcycle works normally.
2. Hold the front brake handle or step on the rear brake
pedal, fully hold the clutch handle or the engine is in N
gear , and turn on the electric start control switch.
3. Press the electric start button to start the motorcycle.
4. After starting, preheat for 3 ~ 5 minutes under the idling
state. Only after the motorcycle is warmed up can it run
normally.
OPERATION GUIDE
Start up
and preheating
1. If it cannot be started electrically, turn off the ignition
lock, wait for a few seconds to protect the battery, and
then restart it. Do not exceed 5S at each start, and each
interval should not be less than 10s. If the startup fails 3
consecutive times, check the vehicle.
2. In order to prolong the service life of the motorcycle,
when driving under cold conditions, please make sure
that the user warms up for 3-5 minutes before driving,
and at the same time stop high-speed driving. During
preheating, it is forbidden to increase the throttle.
CAUTION
To Next Page
Loading...