.
40
.
Inspection of wheels
MAINTENANCE
When adjusting the spoke nut, please carry out the
adjustment according to the torque value requirements
to avoid the spoke breaking during driving due to the
excessive torque value after the adjustment. Torque value
of front spoke nut: 3.2~3.5N · m; Torque value of rear spoke
nut: 3.5~3.8N · m.
Outer tire wear limit value
Yaw limit value of wheel
Outer tire
wear limit
value
Front
wheel
Twi scale mark
Rear wheel Twi scale mark
Yaw limit value of
wheel
Axial direction 2.0mm
Radial direction 2.0mm
1. If the tire pressure is too high, the riding comfort will be
reduced and the wear of various parts will be accelerated. If the
tire pressure is too low, the rolling resistance of the tire will get
increased and the fuel consumption will be increased. In serious
cases, part delamination of the tire will result in tire burst.
2. If the inner tube valve core leaks, repair or replace the valve
core. Repair or replace the tube when it leaks.
3. Regularly check and adjust the wheels at our special service
center.
a. Precautions for parking in low temperature environment (below
- 10C °).When the outdoor environment is lower than - 10C ° and
the vehicle needs to be parked for a long time: it is recommended
to park indoors: it is recommended to avoid the use of side braces,
and the parking frame should be used for parking,keep tires free
from vehicle gravity: It is recommended to avoid parking tires on ice
and snow.
b. Storage of tires.The recommended tire storage temperature is
higher than -5C°.It is recommended to park the tire for 24h under
the environment of no less than 0 ° when changing the tire.
c. Optimum operating temperature of tire.At the beginning of
driving in cold weather, it is necessary to warm the tir
es and drive
slowly at a speed of 40-50km. After driving for 3-5 km, when the
temperature of the tires rises by more than 30C °, you can exert
good grip.
40-60C °
groove will appear flexure lines (similar to skin wrinkles).
The reason is that the semi hot melt tire has good grip and large
hysteresis, which only occurs on the surface. It will not extend to the
inside of the tire and will not affect the use.
Instructions for use of selecting semi hot melt tires
DANGER
To Next Page
Loading...