.
43
.
Cleaning and storage
1. Motorcycle cleaning
Before cleaning the vehicle, the vehicle must be in the flameout state. After the engine is cooled, block the air outlet at
the tail of the exhaust pipe, and then wash the outside of the vehicle. During cleaning, pay attention to that the water gun
pressure should not be too high, otherwise the lubricating grease will be washed clean (such as wheel bearings, steering
column bearings, oil seals, etc.).
When washing the motorcycle, try to avoid high-pressure water washing directly into electrical parts (such as switches,
instruments, voltage regulators, relays, etc.), electronic injection parts, and avoid high-pressure water spraying into
internal parts (such as the back of lamps and instruments, slot of storage box, etc.), so as to prevent electrical short circuit
and water entering the storage box. (3). After cleaning, wipe the surface of the motorcycle with a clean cotton cloth or
clean towel. (4). After cleaning, it is necessary to stand for more than 10 minutes so that the water accumulated on the
motorcycle can be drained before starting the vehicle.
2. Storage of motorcycle
(1). Before long-term parking, drain the fuel from the fuel tank and oil pipe, and then install the fuel tank cover. Motorcycle
that have not been used for a long time should be started at least once a month to avoid blockage of oil passages. (2).
Remove the spark plug, pour 5ml of new lubricating oil into the spark plug hole, inject it into the cylinder, and install the
spark plug. And rotate the engine crankshaft for several turns, so that the injected lubricating oil can be evenly distributed
in the combustion chamber to lubricate the cylinder wall.
(3) Remove the b
attery and charge it slowly for one time. Store the battery in a dry, dark and indoor environment. Do
cleaning and lubrication. After filling the tire pressure to the specified value, use wood blocks to raise the tire so that the
tire does not contact the ground. (5) After storage, it should be stored in a ventilated, dry, clean, rain-proof and sun-proof
environment, away from flammable, chemical corrosive and other harmful substances. (6). When used after storage, it
should be fully cleaned and checked once, then fuel should be added and the battery should be slowly charged once. If it
is stored for more than 4 months, the engine lubricating oil shall be replaced.
MAINTENANCE
To Next Page
Loading...