.
33
.
1
2
MAINTENANCE
Engine oil filter
3. Re move the oil plug on the r ight cove r, add the
corresponding brand of lubricating oil from the oil plug on
the right cover, observe the oil level while adding oil, and
stop refueling until the oil level reaches the upper line of the
oil observation window. In the end, install the oil plug on the
right cover and tighten it.
4. Start the engine and let it run for several minutes, and
check whether there is oil leakage at the disassembled parts
of the engine.
5. Turn off the engine and wait a few minutes before checking
the oil level. The oil level should be between the upper and
lower limits of the oil dipstick.
Instructions for use of oil filter: 1. Replace it every 10000KM
or 250h.
2. Apply a little oil on the sealing ring, and then install and
tighten it.
3. Start the engine and check whether there are any oil leaks
and oil levels.
Tightening torque of oil filter
: 17.2N. m
To Next Page
Loading...