Cyfral CC4000 - Installer Functions; Installer Passcode Recovery; Service Key Fob Usage; Installation Mode

~22~
7. INSTALLER FUNCTIONS
7.1. Recovery of the installer passcode
In the case of losing a passcode, or lack of knowledge regarding thereof, it is possible to recover it. You can do it in
two ways. The first option is to return the equipment to the CYFRAL service, after prior contact. The second method
is to read the encrypted code from the keypad of the panel you are interested in.
To do this, enter the following sequence from the keypad: . On the display there will appear the field for
entering the serial number of the panel . Enter the serial number and confirm it with the key .
The first part of the code made up of sixteen positions will appear for five seconds. To display the second part, press
the key . If the code cannot be completely written down, the action should be repeated. To facilitate the process,
you can use a camera.
With the code obtained in this way, please contact CYFRAL to decipher the password.
7.2. Service key fob
In order to facilitate the installation procedure, you can assign an RFID proximity key to the PC-4000 panel. The key
is assigned to the program in subprogram 7: .
In order to use the key added as such to enter the programming procedure, enter into the panel in the idle
mode and hold the programmed key against it. The panel will automatically enter the programming mode without
need for entering the serial number and password.
Selecting "NO" in the subprogram assigning the service key deletes the existing key.
If the service key is used to enter the programming mode, the password change function and factory settings are
disabled.
7.3. Installation mode
The CC4000 system enables the intercom system to be operated by one person. To start the installation mode, use
the subprogram of the program described in item 3.3.8. The function remains active for the set
time. During this time, the panel remains blocked, connections cannot be made. Pressing any key activates the main
electromagnetic lock for the programmed time. Pressing the key five times discontinues the installation procedure
and restarts the panel.