Cygnus M5-C2P - Connecting the Probe

M5-CYG2P-M-01_Iss6.doc
Cygnus 2+ Operating Manual
11
To avoid damage from leaking batteries always remove the
batteries if the gauge will be unused for any length of time.
If the batteries run flat they may leak acid into the battery
compartment and damage the electrical contacts. This would
not be covered by the warranty.
Connecting the Probe
The Cygnus probe lead uses a custom made cable that offers
superior flexibility and resistance to oils and ultraviolet light. The
cable will not stiffen after exposure to ultraviolet light.
T
he connector uses original Lemo connectors for reliability. The
twin connectors are over-mounded to form a tough housing that
will provide a long lasting probe cable
T
he connector is orientated with a ‘pip’ and can only be plugged in
one-way around.
Depending on the type
of probe supplied the
probe end will have
either a twin Lemo 00,
BNC or single Lemo 00
connector.