Cygnus M5-C2P - Selecting the Probe Type

Cygnus 2+ Operating Manual
M5-CYG2P-M-01_Iss6.doc
40
• Measurement mode
• Units
• Resolution
• Velocity of sound
• Calibration
• Deep Coat (if a single element probe)
Selecting the Probe Type
The Probe Type must be set to the probe connected to it. If
the wrong probe is selected the gauge will not measure
accurately if at all.
The gauge can Auto Detect certain types of probes when they are
first connected to the gauge, or you can manually select the probe
from a list.
These probes can be Auto Detected;
T2C, T5B, T7A, S2C
These probes must be selected manually;
S2D, S3C, S5A & S5C
1.
Press the Menu key
2.
Press the Up Select key to get to
the Probe Type item