Cygnus M5-C2P - Page 45

M5-CYG2P-M-01_Iss6.doc
Cygnus 2+ Operating Manual
45
coatings like rubber or bitumen don’t transmit ultrasound very
well.
Deep Coat is only available in Multiple Echo mode.
Using Deep Coat will not affect the calibration.
Turn Deep Coat Off when NOT measuring through thick
coatings otherwise this may cause inaccurate measurements.
1.
Press the Menu key
2.
Press the Up Select key to get to
the Deep Coat item
3.
Press the Menu key to change
the value
4.
Use the Up and Down Select
keys to switch from On to Off
5.
When done press the Menu key
to save the new setting.
Or press the Power / Cancel to
exit without saving.