© 2021 Cypress Solutions Manual: CTM-ONE (Revision 1.0)
The CTM-ONE can be configured to remain on for a defined period after the standby/ignition signal has been
turned off. This enables the gateway to continue sending position reports or be used for data operations even
after the vehicle ignition has been switched off – e.g., for short duration driver breaks.
When in its power shutdown mode, the gateway may be configured to resume full operation by monitoring
events such as:
• Acceleration
• GPS location (on board Geo-Fence)
• Time
• Speed
• Temperature
• Voltage
• Input events
7.2 Power Consumption
The power consumption of the CTM-ONE gateway will depend on its supply voltage, its current operating
function, and its RF environment.
The following table is provided to assist application integrators in defining the power requirements for their
specific application. The overall power consumption is related to the overall “duty cycle” of the device. Fixed
site applications requiring infrequent polling will require a low duty cycle whereas a mobile solution will require
a higher duty cycle to account for accurate geo-location.
To Next Page
Loading...