Cypress CTM-ONE - Physical Interfaces; Ethernet; General Purpose Input and Outputs (GPIO);Serial; Auxilliary and iButton

To Next Page

To Previous Page

Physical Interfaces

3. Physical Interfaces

3.1 Ethernet

• One Ethernet port (bridged/non-bridged)

• Ethernet services can be disabled

• Ethernet ports can use DHCP or static IP addresses, DHCP can be configured to a single IP address

• Gateway support when an Ethernet port is used to connect to the Internet through another router

• Static NAT support

3.2 General Purpose Input and Outputs (GPIO)/Serial

• 14 position interfaces

• Inputs x 4 (2 differential)

• Outputs x 4

• Console, Command Line Interface access

• PAD host interface (1 available), Virtual Serial Line replacement

• MODBUS host interface, MODBUS interface

• Various auxiliary device support (contact Cypress Solutions for more details)

3.3 Auxilliary and iButton™

• 10 position interfaces

• Auxiliary equipment interface

• iButton™ interface access control hardware interface

3.4 USB OTG (On-The-Go) port

• USB device port

3.5 CAN Bus port

• 8 position interfaces including power

• Automotive CAN support (J1939, OBD2/ISO15765-4)

• Silent mode support

• 2 CAN Interfaces:

• 1: HS-CAN (J1962 pin 6,14)

• 2: HS-CAN/MSCAN (J1962 pin 3,11)

• SWCAN (J1962 pin 1)

3.6 Locking 3 Wire power connector with ignition sense

• 4 pin interfaces

• 7-32 VDC with transient (spike) protection

• .1 to 3 mA @ 12 Volts low power mode (feature dependent)