CY8CKIT-059 PSoCĀ® 5LP Prototyping Kit Guide, Doc. #: 001-96498 Rev. *G 32
Code Examples
4. Build the code example by choosing Build > Build <Project Name>, as shown in Figure 5-2. A
.hex file is generated after the build process.
Figure 5-2. Open Code Example from PSoC Creator
5. Connect the PSoC 5LP Prototyping Kit to the PC using the KitProg PCB USB port, J10 as
described in Figure 3-2 on page 17 to program the kit with this code example.
6. Choose Debug > Program in PSoC Creator as shown in Figure 5-3.
Figure 5-3. Program Device in PSoC Creator
To Next Page
Loading...
