What to do if there is a power failure during a run of cytiva UniFlux 120 Laboratory Equipment?
If you encounter a power failure during a run with Cytiva Laboratory Equipment, check the circuit breaker both in the system and for the external supply, as applicable.
How to troubleshoot little or no flow in cytiva UniFlux 120 Laboratory Equipment?
If you experience little or no flow in Cytiva Laboratory Equipment, verify that the connected inlet is actually in use. Ensure that inlet containers are not placed too low relative to the pump. Confirm that liquid is being supplied to the pump by checking the inlet containers. Also, examine the tubing from the inlet container for issues such as excessive length, too small internal diameter, narrow sections, or blockages. Finally, check for a malfunctioning valve at the container battery limit.
What causes high flow in the air integrity test of cytiva UniFlux 120?
If the flow is too high during the air integrity test for Cytiva Laboratory Equipment, it may be due to a clogged filter. Try cleaning the filter to resolve this issue.
What causes low flow in the air integrity test of Cytiva Laboratory Equipment?
If the flow is too low during the air integrity test for Cytiva Laboratory Equipment, it may be because the pores in the membrane or fibers have become larger than the nominal size, or because the fibers or membranes are broken. In either case, you should change the filter.
What to do if there is little or no flow in cytiva UniFlux 120 Laboratory Equipment?
If you see little or no flow in Cytiva Laboratory Equipment, check the pump hose. If it is broken or damaged, contact your local Cytiva representative.
What to do if there is a dirty UV cell in Cytiva Laboratory Equipment?
Clean the UV cell.
Why is the pH reading incorrect on cytiva UniFlux 120 Laboratory Equipment?
If the pH reading appears to be incorrect on Cytiva Laboratory Equipment, calibrate the pH-sensor.
How to fix 'No system found' when starting UNICORN on Cytiva Laboratory Equipment?
To resolve the issue of no system being found when starting up UNICORN on Cytiva Laboratory Equipment, ensure the system is switched on, check the communication cable and connectors, and reboot the PC by shutting down Windows, switching off the system power, waiting at least 5 seconds, and then restarting the system.
What to do if the pump of Cytiva Laboratory Equipment does not reach desired pressure?
If the pump does not reach the desired pressure in Cytiva Laboratory Equipment, check if the regulator is set below the desired pressure and adjust it accordingly. Also, check the oil level in the reservoir; if it's low, add oil until it reaches approximately 60% of the reservoir's volume (3 L).
How to troubleshoot high outlet pressure in Cytiva Laboratory Equipment?
If you observe too high outlet pressure in Cytiva Laboratory Equipment, verify that the connected outlet is actually in use and that outlet containers are not placed too high relative to the pump. Check the tubing to the outlet container for issues such as excessive length, too small internal diameter, narrow sections, or blockages. Also, check for non-functioning valves and any malfunctioning valve at the container battery limit.
General| Brand | cytiva |
|---|---|
| Model | UniFlux 120 |
| Category | Laboratory Equipment |
| Language | English |
Crucial safety and operational guidelines before using the product.
Essential safety measures for operating and maintaining the UniFlux system.
Outlines procedures for emergency shutdown and restart after power failure.
Explains the UNICORN software control system for UniFlux automation.
Outlines necessary space, floor load, and environmental conditions for system installation.
Details precautions and steps for safely unpacking the UniFlux system.
Guides through the process of setting up the UniFlux system after unpacking.
Guide on fitting and connecting the operator console to the UniFlux system.
Overview of power requirements, installation, and UPS considerations for UniFlux.
Instructions for starting the UniFlux system and the UNICORN software.
Details precautions and steps for starting, monitoring, and ending a filtration run.
To Next Page