Why does Cytiva Laboratory Equipment have erratic flow and noisy signals?
If you observe erratic flow, a noisy baseline signal, or an irregular pressure trace, it could be due to gas bubbles passing through or trapped in the pump. Ensure there is a sufficient supply of liquid. Also, check all connections for leaks. A blockage or partial blockage of the flow path can also cause these issues, so flush the system to clear any blockages.
Why is there a noisy UV signal in cytiva UniFlux 120 Laboratory Equipment?
If you observe a noisy UV signal, signal drift, or instability in Cytiva Laboratory Equipment, the cause may be bad UV fiber connections. Check the connections of the UV cell optical fiber, and replace them if necessary.
What to do if the pump is not working in cytiva UniFlux 120 Laboratory Equipment?
If the pump of Cytiva Laboratory Equipment is not working, first check if the emergency button has been pressed. Also, ensure that there is an inlet or outlet valve open. If the method is incorrect, check by entering Pump ?ManFlow > 1%. If none of these steps resolve the issue, contact Cytiva service personnel.
What to do if Cytiva Laboratory Equipment shows 'No air supply to the system' alarm?
If you experience a compressed air failure during a run, indicated by the “No air supply to the system” alarm and the system entering Pause mode, it may be due to insufficient air pressure from malfunctioning air supply equipment or a leaking air hose. To resolve this, rectify the air supply problem and then restart the run by pressing the Continue button.
What to do if there is a dirty UV cell in Cytiva Laboratory Equipment?
Clean the UV cell.
What to do if there is little or no flow in cytiva UniFlux 120 Laboratory Equipment?
If you see little or no flow in Cytiva Laboratory Equipment, check the pump hose. If it is broken or damaged, contact your local Cytiva representative.
What causes low flow in the air integrity test of Cytiva Laboratory Equipment?
If the flow is too low during the air integrity test for Cytiva Laboratory Equipment, it may be because the pores in the membrane or fibers have become larger than the nominal size, or because the fibers or membranes are broken. In either case, you should change the filter.
What causes high flow in the air integrity test of cytiva UniFlux 120?
If the flow is too high during the air integrity test for Cytiva Laboratory Equipment, it may be due to a clogged filter. Try cleaning the filter to resolve this issue.
How to troubleshoot little or no flow in cytiva UniFlux 120 Laboratory Equipment?
If you experience little or no flow in Cytiva Laboratory Equipment, verify that the connected inlet is actually in use. Ensure that inlet containers are not placed too low relative to the pump. Confirm that liquid is being supplied to the pump by checking the inlet containers. Also, examine the tubing from the inlet container for issues such as excessive length, too small internal diameter, narrow sections, or blockages. Finally, check for a malfunctioning valve at the container battery limit.
General| Brand | cytiva |
|---|---|
| Model | UniFlux 120 |
| Category | Laboratory Equipment |
| Language | English |
Crucial safety and operational guidelines before using the product.
Essential safety measures for operating and maintaining the UniFlux system.
Outlines procedures for emergency shutdown and restart after power failure.
Explains the UNICORN software control system for UniFlux automation.
Outlines necessary space, floor load, and environmental conditions for system installation.
Details precautions and steps for safely unpacking the UniFlux system.
Guides through the process of setting up the UniFlux system after unpacking.
Guide on fitting and connecting the operator console to the UniFlux system.
Overview of power requirements, installation, and UPS considerations for UniFlux.
Instructions for starting the UniFlux system and the UNICORN software.
Details precautions and steps for starting, monitoring, and ending a filtration run.
To Next Page