Why is there a noisy UV signal in cytiva UniFlux 30?
If you observe a noisy UV signal, signal drift, or instability in Cytiva Laboratory Equipment, the cause may be bad UV fiber connections. Check the connections of the UV cell optical fiber, and replace them if necessary.
What to do if the pump is not working in Cytiva Laboratory Equipment?
If the pump of Cytiva Laboratory Equipment is not working, first check if the emergency button has been pressed. Also, ensure that there is an inlet or outlet valve open. If the method is incorrect, check by entering Pump ?ManFlow > 1%. If none of these steps resolve the issue, contact Cytiva service personnel.
What to do if cytiva UniFlux 30 Laboratory Equipment shows 'No air supply to the system' alarm?
If you experience a compressed air failure during a run, indicated by the “No air supply to the system” alarm and the system entering Pause mode, it may be due to insufficient air pressure from malfunctioning air supply equipment or a leaking air hose. To resolve this, rectify the air supply problem and then restart the run by pressing the Continue button.
What to do if there is a dirty UV cell in cytiva UniFlux 30?
Clean the UV cell.
What to do if there is little or no flow in cytiva UniFlux 30?
If you see little or no flow in Cytiva Laboratory Equipment, check the pump hose. If it is broken or damaged, contact your local Cytiva representative.
What causes low flow in the air integrity test of cytiva UniFlux 30 Laboratory Equipment?
If the flow is too low during the air integrity test for Cytiva Laboratory Equipment, it may be because the pores in the membrane or fibers have become larger than the nominal size, or because the fibers or membranes are broken. In either case, you should change the filter.
What causes high flow in the air integrity test of Cytiva Laboratory Equipment?
If the flow is too high during the air integrity test for Cytiva Laboratory Equipment, it may be due to a clogged filter. Try cleaning the filter to resolve this issue.
How to troubleshoot little or no flow in cytiva UniFlux 30?
If you experience little or no flow in Cytiva Laboratory Equipment, verify that the connected inlet is actually in use. Ensure that inlet containers are not placed too low relative to the pump. Confirm that liquid is being supplied to the pump by checking the inlet containers. Also, examine the tubing from the inlet container for issues such as excessive length, too small internal diameter, narrow sections, or blockages. Finally, check for a malfunctioning valve at the container battery limit.
General| Applications | diafiltration |
|---|---|
| Flow Rate | Up to 30 L/min |
| Column Size | Not applicable |
| Connectivity | Ethernet |
| Temperature Range | 4 to 40°C |
| pH Range | 2 |
To Next Page