D-Box G5 - Page 28

28
231-914-0001-EN5
LED STATUS
STATUS
SOLUTION
Blinking amber
No Motion Player
detected / no
communication.
System fault or haptic
actuator has not been set
to the right voltage.
Actuator fault
Make sure the USB cable is properly connected (both
ends). Do not use a USB HUB.
Make sure you have the latest version of Motion Core
installed.
Verify that all haptic actuators are set to your region’s
power voltage (see section 3).
Use the D-BOX System Monitor software to see the
system fault (see section 10.5).
Blinking amber &
green
Haptic actuators
communication issue.
Make sure the actuator power and RJ45 cables are
properly connected.
Make sure the RJ45 cables are connected into the right
ports of the Haptic Bridge (see sections 6.2 – 6.5).
The system is operational
-
REAR PANEL
LEDS STATUS