DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
Configuring Device (Router Mode)
NTP Client
On the System / NTP client page, you can configure automatic synchronization of the system
time with a time server on the Internet.
Figure 153. The System / NTP client page.
To enable automatic synchronization with a time server:
1. Select the Enabled checkbox.
2. Select your time zone.
3. Specify the needed NTP server in the NTP servers field or leave the server specified by
default.
4. Click the Change button.
!
When the access point is powered off or rebooted, the system time is reset to the default
value. If you have set automatic synchronization for the system time, the internal clock of
the device will be configured after connecting to the Internet.
Page 171 of 175
To Next Page
Loading...
