DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
Configuring Device (Router Mode)
Site Setup Wizard
To create a virtual server for redirecting incoming Internet traffic to a specified IP address in the
LAN, click the Host site button.
Figure 85. The page for adding a virtual server.
On the opened page, you can specify the following parameters:
Parameter Description
Name
Enter a name for the virtual server for easier identification. You can
specify any name.
Interface
Select a WAN connection to which this virtual server will be
assigned.
Private IP
Enter the IP address of the server from the local area network. To
choose a device connected to the access point's LAN at the moment,
select the relevant value from the drop-down list located to the right
of the Private IP field (the field will be filled in automatically).
Remote IP
Enter the IP address of the server from the external network.
When needed settings are configured, click the Save button. After that you get to the quick settings
page.
Page 93 of 175
To Next Page
Loading...
