DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
Configuring Device (Access Point Mode)
System
In this menu you can do the following:
• change the password used to access the access point's settings
• save the current settings to the non-volatile memory
• create a backup of the access point's configuration
• restore the access point's configuration from a previously saved file
• restore the factory default settings
• view the system log
• update the firmware of the access point
• allow or forbid access to the access point via TELNET.
Administrator Password
On the System / Administrator password page, you can change the password for the
administrator account used to access the web-based interface of the access point and to access the
device settings via TELNET.
!
For security reasons, it is strongly recommended to change the administrator password
upon initial configuration of the access point.
Figure 55. The page for modifying the administrator password.
Enter the new password in the Password and Confirmation fields and click the Save button.
Page 65 of 175
To Next Page
Loading...
