12 DAP-1665 Install Guide
Connect Your Wireless Devices
From your wireless device go to the Wireless Utility to display the available
wireless networks and select the Wi-Fi Network Name (SSID) that is located
on your conguration card (ex: dlink-a8fa). Then, enter the Wi-Fi password
which is also located on your conguration card. (ex: akbdj19368).
Wi-Fi Name(SSID) 2.4Ghz:
dlink-xxxx
Wi-Fi Name(SSID) 5GHz:
dlink-xxxx-5GHz
Password: xxxxxxxx
To congure your router, go to:
http://dlinkrouter.local.
Or http://192.168.0.1
Username: “Admin”
Password:” “ (leave the eld blank)
Your device is now connected to the DAP-1665 and can connect to your
wireless router. If you want to change your network settings, password, etc.,
follow the steps on page 14 to Congure Using a Web Browser. To connect
additional devices, repeat step 4.
Your setup is complete!
4
5
Note: For optimal performance using Repeater Mode, place your DAP-1665 in between your router
and your dead zone, making sure it’s placed in a location where the signal is still strong.
RESET
LAN
5V
1A
To Next Page
Loading...
