D-Link DFE-690TXD Quick Install Guide

7 D-Link DFE-690TXD Quick Install Guide
Configure Your Adapter
Configure your Adapter
After you install your new D-Link adapter, by default, the TCP/IP
settings should be set to obtain an IP address from a DHCP server
(i.e. router) automatically. To verify your IP address, please follow
the steps below.
Windows
®
2000/XP: Click on Start > Run. In the run box type cmd
and click OK.
Windows
®
7/Vista
®
: Click on Start > All Programs > Accessories
> Command Prompt.
At the prompt, type ipconfig
and press Enter.
This will display the IP
address, subnet mask, and
the default gateway of your
adapter.
If the address is 0.0.0.0, check your adapter installation, security
settings, and the settings on your router. Some rewall software
programs may block a DHCP request on newly installed adapters.
If you are connecting to a wireless network at a hotspot (e.g. hotel,
coffee shop, airport), please contact an employee or administrator
to verify their wireless network settings.
For more information on setting your IP address, please refer to the
manual.

D-Link DFE-690TXD Specifications

General

Brand	D-Link
Model	DFE-690TXD
Category	Adapter
Language	English