13
Properties” dialog box.
3. Double-Click “Network Adapters” if you do not see any items
branching out. You should see “D-Link DFE-690TXD Cardbus
PC Card” branching out after double-clicking “Network
Adapters.”
If you do not see any items branching out after double-clicking “Network
Adapters,” your Network Adapter has not been properly installed. Start
at the beginning of the “Quick Install Guide.”
If you see symbols such as yellow exclamation point or red “X” over the
icon adjacent to “D-Link DFE-690TXD Cardbus PC Card,” your card is
not installed properly or may have a problem. Double-click the “ D-Link
DFE-690TXD Cardbus PC Card ” and read the explanation of the
problem. This information will be helpful if you require technical
support from D-Link.
Verify Cable Connections
Check to see that the computer you are troubleshooting is properly
connected. Each computer must be connected from its DFE-690TXD
with Category 5 cables. Examine the network cables and ensure that
being walked-on, rolled over by chairs, or caught in doors, has not
damaged them. Additionally, make note of and alleviate any possible
electromagnetic interference that may be affecting your network.
Your network cables can be plugged into any port on your hub except the
To Next Page
Loading...
Need help?
General
