DGS-3100 Series Gigabit Stackable Managed Switch Hardware Installation Guide
Troubleshooting Device Connections
Ensure the terminal or PC connection is configured to match the below settings.
If problems occur while connecting to the PC, ensure the emulation is set to VT-100. To set the emulation, select File >
Properties > Settings tab in the HyperTerminal window. The Emulation options are displayed in the HyperTerminal
Window:
Figure 3-7. Settings Tab in HyperTerminal Window
If the Emulation options are not displayed in the HyperTerminal window, reboot the device by disconnecting the power
supply.
27
To Next Page
Loading...
Need help?
General