13D-Link DHP-W306AV User Manual
Section 2 - Installation
Powerline Network - Quick Setup
Encryption Button Usage
The Eny Button is used to add a Powerline AV device to a Powerline network. You can allow the DHP-W306AV to join
a network by pressing the Eny Button to toggle it to the Broadcast state or Join state.
The Eny Button has 3 different trigger states:
Enables the DHP-W306AV to provide information for another Powerline AV device
to join its Powerline network (works even if it is the only device existing within the network group). The
rst Powerline device will use this state when the Eny Button is pressed.
This allows an ungrouped Powerline AV device to join an existing Powerline network.
Powerline devices added after the rst device will be in the Join State when the Eny Button is pressed.
Hold down the Eny Button for more than 10 seconds to detach the device from its
network group.
To Next Page
