65D-Link DHP-W306AV User Manual
Section 6 - Troubleshooting
• Congure your Internet settings:
• Go to . Double-click the Icon. From the tab,
click the button to restore the settings to their defaults.
• Click the tab and set the dial-up option to . Click the
button. Make sure nothing is checked. Click .
• Go to the tab and click the button to restore these settings to their defaults. Click
three times.
• Close your web browser (if open) and open it.
• Access the web management. Open your web browser and enter the IP address of your D-Link access point in the
address bar. This should open the login page for your the web management.
• If you still cannot access the conguration, unplug the power to the access point for 10 seconds and plug back in.
Wait about 30 seconds and try accessing the conguration. If you have multiple computers, try connecting using a
different computer.
If you forgot your password, you must reset your access point. Unfortunately this process will change all your settings
back to the factory defaults.
To reset the access point, locate the reset button (hole) on the rear panel of the unit. With the access point powered
on, use a paperclip to hold the button down for 5 seconds. Release the button and the access point will go through
its reboot process. Wait about 30 seconds to access the access point. The default IP address is . When
logging in, the username is and leave the password box empty.
To Next Page
Loading...
