D-Link DHP-W312AV - Installation; Hardware Installation

11D-Link DHP-W312AV User Manual
Section 2 - Installation
Hardware Installation
Power
Plug the DHP-W312AV into an AC wall outlet where you want to extend your network. The Power LED on the DHP-W312AV will turn on to indicate
it is receiving power. This may take up to 60 seconds.
Plug in the Ethernet Cable
Connect one end of the supplied CAT5 Ethernet cable to the Ethernet port on the DHP-W312AV and the other end of the cable to the device’s
Ethernet interface.
Connect to Existing Network
Press the Common Connect Button or Simple Connect Button on the existing Powerline AV device for 3 seconds. Then, press the Common
Connect Button on the DHP-W312AV PowerLine AV 500 Wireless AC600 Extender for 3 seconds. This must be done within two minutes after
pressing the Simple Connect Button on the rst device. The Powerline devices will then reboot. Read the Wi-Fi advice on the next page, and
continue to Conguration.
Note: Network connectivity is conrmed when the Powerline LEDs indicators on both Powerline devices are steadily lit. This will indicate that your network
is now secure.
Note: A minimum of two Powerline devices (your DHP-W312AV and another pre-existing device) are required to create a Powerline network.
ROOM A ROOM B ROOM C
DHP-W312AV DHP-W312AV
Pre-existing
Powerline device
RouterInternet
Notebook Notebook
iPad iPad