D-Link DHP-W312AV - System

27D-Link DHP-W312AV User Manual
Section 3 - Conguration
System
Save Settings To
Local Hard Drive:
Load Settings From
Local Hard Drive:
Restore to
Factory Default
Settings:
Reboot the
Device:
Use this option to save the current DHP-
W312AV conguration settings to a le on
the computer you are using. Click the Save
button. You will then see a le dialog where
you can select a location and le name for
the settings.
Use this option to load previously saved
DHP-W312AV configuration settings.
Click Browse to find a previously saved
conguration le. Then, click the Upload
Settings button to transfer those settings
to the DHP-W312AV.
This option will restore all conguration
settings back to the settings that were in
eect at the time the DHP-W312AV was
shipped from the factory. Any settings that
have not been saved will be lost, including
any rules that you have created. If you
would like to save the current DHP-W312AV
conguration settings, use the Save button
above.
Click to reboot the DHP-W312AV.
This page lets you both save and delete settings on your DHP-W312AV.