DIR-300A Wireless N150 Router
User Manual
Configuring via Web-based Interface
Telnet
On the System / Telnet page, you can enable or disable access to the device settings via TELNET
from your LAN. By default, access is enabled.
Figure 139. The System / Telnet page.
To disable access via TELNET, deselect the On checkbox and click the Apply button.
To enable access via TELNET again, select the On checkbox. In the Port field, enter the number of
the router's port through which access will be allowed (by default, the port 23 is specified). Then
click the Apply button.
Page 176 of 181
To Next Page
Loading...
