DIR-300A Wireless N150 Router
User Manual
Configuring via Web-based Interface
Net
In this menu you can configure basic parameters of the router's local area network and configure
connection to the Internet (a WAN connection).
WAN
On the Net / WAN page, you can create and edit connections used by the router.
By default, a Dynamic IP connection and a Dynamic IPv6 connection are configured in the
system. They are assigned to the WAN port of the router. You can edit these connections or delete
them.
Figure 61. The Net / WAN page.
To create a new connection, click the Add button. On the page displayed, select the needed value
from the Connection Type drop-down list and specify the relevant values.
To edit an existing connection, left-click the relevant line in the table. On the page displayed,
change the parameters and click the Apply button.
To remove a connection, select the checkbox located to the left of the relevant line in the table and
click the Delete button. Also you can remove a connection on the editing page.
To use one of existing WAN connections as a default IPv4 gateway, select the choice of the Default
gateway radio button located in the line corresponding to this connection.
To use one of existing WAN connections as a default IPv6 gateway, select the choice of the Default
IPv6 gateway radio button located in the line corresponding to this connection.
Page 77 of 181
To Next Page
Loading...
