D-Link DIR-524 - Connecting to Wireless Network; Using Windows XP

Section 5 – Connecting to a Wireless Network
————————————————————————————————————————————————————————————
D-Link DIR-524 User Manual 52
Using Windows
®
XP
Windows
®
XP users may use the built-in wireless utility (Zero Configuration Utility). The following instructions are for
Service Pack 2 users. If you are using another company’s utility or Windows
®
2000, please refer to the user manual
of your wireless adapter for help with connecting to a wireless network. Most utilities will have a “site survey” option
similar to the Windows
®
XP utility as seen below.
If you receive the Wireless Networks Detected bubble,
click on the center of the bubble to access the utility.
or
Right-click on the wireless computer icon in your system
tray (lower-right corner next to the time). Select View
Available Wireless Networks.
The utility will display any available wireless networks in
your area. Click on a network (displayed using the SSID)
and click the Connect button.
If you get a good signal but cannot access the Internet,
check you TCP/IP settings for your wireless adapter.
Refer to the Networking Basics section in this manual
for more information.