D-Link DIR-825+ - Page 47

43D-Link DIR-825+ User Manual
Section 3 - Conguration
INTERNET CONNECTION TYPE
Choose the mode to be used by the router to connect to the Internet.
My Internet Connection is :
PPTP (Username / Password)
▼
Save Settings Don’t Save Settings
PPTP INTERNET CONNECTION TYPE :
Enter the information provided by your Internet Service Provider (ISP).
Address Mode :
 Dynamic IP  Static IP
PPTP IP Address :
PPTP Subnet Mask :
PPTP Gateway IP Address :
PPTP Server IP Address :
Username :
Password :
Verify Password :
Reconnect Mode :

AlwaysOn
▼
New Schedule
 On Demand  Manual
Maximum Idle Time :
(minutes)
Primary DNS Server :
Secondary DNS Server : (optional)
MTU : 1400
MAC Address :
Clone Your PC’s MAC Address
WANINTERNET
DIR-825+
SETUP
WAN
Use this section to congure your Internet Connection type. There are several connection types to choose from: Static IP, DHCP, PPPoE,
PPTP, L2TP, DS-Lite and Russia PPPOE. If you are unsure of your connection method, please contact your Internet Service Provider.
Note : If using the PPPoE option, you will need to remove or disable any PPPoE client software on your computers.
Save Settings Don’t Save Settings
PPTP (Username / Password) (Continued)
Maximum Idle
Time:
Set the length of time to wait before disconnecting if there is no
Internet activity. (Manual Only.)
Primary DNS
Server:
Enter the primary DNS server IP addresses.
Secondary DNS
Server :
Enter the secondary DNS server IP addresses.
MTU Size: Enter the MTU size.
MAC Address: If your Internet connection is tied to a specic PC or hardware, enter
it manually or click Clone Your PC’s MAC Address.
If your ISP requires the use of 80211Q VLAN tagging, see VLAN on page 49.
When you have nished conguring your Internet connection, click the Save Settings
button.
VLAN :
VLAN