D-Link DIR-825+ - Page 49

45D-Link DIR-825+ User Manual
Section 3 - Conguration
Maximum Idle
Time:
Set the length of time to wait before disconnecting if there is no
Internet activity. (Manual Only.)
Primary DNS
Server:
Enter the primary DNS server IP addresses.
Secondary DNS
Server :
Enter the secondary DNS server IP addresses.
MTU Size: Enter the MTU size.
MAC Address: If your Internet connection is tied to a specic PC or hardware, enter
it manually or click Clone Your PC’s MAC Address.
INTERNET CONNECTION TYPE
Choose the mode to be used by the router to connect to the Internet.
My Internet Connection is :
L2TP (Username / Password)
▼
Save Settings Don’t Save Settings
L2TP INTERNET CONNECTION TYPE :
Enter the information provided by your Internet Service Provider (ISP).
Address Mode :
 Dynamic IP  Static IP
L2TP IP Address :
L2TP Subnet Mask :
L2TP Gateway IP Address :
L2TP Server IP Address :
Username :
Password :
Verify Password :
Reconnect Mode :

AlwaysOn
▼
New Schedule
 On Demand  Manual
Maximum Idle Time :
(minutes)
Primary DNS Server :
Secondary DNS Server : (optional)
MTU : 1400
MAC Address :
Clone Your PC’s MAC Address
WANINTERNET
DIR-825+
SETUP
WAN
Use this section to congure your Internet Connection type. There are several connection types to choose from: Static IP, DHCP, PPPoE,
PPTP, L2TP, DS-Lite and Russia PPPOE. If you are unsure of your connection method, please contact your Internet Service Provider.
Note : If using the PPPoE option, you will need to remove or disable any PPPoE client software on your computers.
Save Settings Don’t Save Settings
L2TP (Username / Password) (continued)
If your ISP requires the use of 80211Q VLAN tagging, see VLAN on page 49.
When you have nished conguring your Internet connection, click the Save Settings
button.
VLAN :
VLAN