DIR-853 AC1300 MU-MIMO Wi-Fi Gigabit Router
with 3G/LTE Support and USB Port 3.0
User Manual
Configuring via Web-based Interface
-
On the System / Telnet page, you can enable or disable access to the device settings via TELNET
from your LAN. By default, access is disabled.
Figure 171. The System / Telnet page.
To enable access via TELNET, move the Enable Telnet switch to the right. In the Port field, enter
the number of the router's port through which access will be allowed (by default, the port 23 is
specified). Then click the APPLY button.
To disable access via TELNET again, move the Enable Telnet switch to the left and click the
APPLY button.
Page 213 of 228
To Next Page
Loading...
