DIR-853 AC1300 MU-MIMO Wi-Fi Gigabit Router
with 3G/LTE Support and USB Port 3.0
User Manual
Configuring via Web-based Interface
Creating 3G WAN Connection
If the PIN code check is enabled for the SIM card inserted into your USB modem, then prior to
creating a 3G WAN connection, go to the USB Modem menu and enter the PIN code
10
on the page
displayed (see the USB Modem section, page 153). Then on the connection creation page, go to the
All Settings tab, select the relevant value from the Connection type drop-down list, and specify
the needed values.
Figure 76. The page for creating a new 3G connection. Selecting a connection type.
Parameter Description
Enable connection
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
Connection name
Available for the advanced mode only.
A name for the connection for easier identification.
10 For some models of 3G USB modems it is required to disable the PIN code check on the SIM card prior to
connecting the USB modem to the router.
Page 94 of 228
To Next Page
Loading...
