D-Link DSL-224 - Page 12

Section 2 – Installation
D-Link DSL-224 User Manual
10
LED
Color
Status
Description
DSL Green
Off
No signal is being detected.
Blinking
The device is handshaking with the physical layer of the office end.
On
A connection is set up with the physical layer of the office end.
Internet
Green
Off
The device is under the Bridge mode or powered off.
Blinking
Internet data is being transmitted in the routing mode.
On
The IP is connected.
Red
On
The device is attempted to become IP connected, but failed.
Figure 2 Rear panel
The following table describes the interfaces of the device.
Interface/Button
Description
DSL
RJ-11 interface for connecting the host to the telephone jack on the wall or the MODEM interface of the
splitter through a telephone line.
LAN4/3/2/1
For a PC or other Ethernet-abled device to join the LAN of 224 by being connected to this interface with
RJ-45 cable.
WPS
Press the button to enable or disable WPS function.
WIRELESS ON/OFF
Press the button to enable or disable WLAN function.
ON/OFF
Power switch, which is used to power on or power off the device.
12V DC IN (power)
Interface for connecting the power adapter.
Reset (On the bottom side)
Press and hold the button for 15~20 seconds to restore the factory defaults.