Section 3 – Web Configuration
Routing
Static Route
Choose ADVANCED > Routing > Static Route. The page shown in the figure
appears on the right. This page is used to configure the routing information. You
can add or delete IP routes.
The following table describes the parameters and buttons of this page:
Select it to use static IP routes.
Enter the IP address of the destination device.
Enter the subnet mask of the destination device.
Enter the IP address of the next hop in the IP route to the
destination device.
The metric cost for the destination.
The interface for the specified route.
A list of the previously configured static IP routes.
Click Show Routes, the page shown in the right figure appears. The table shows
a list of destination routes commonly accessed by your network.
IPv6 Static Route
Choose ADVANCED > Routing > IPv6 Static Route. The page shown in the
figure appears on the right. This page is used to configure the routing information.
You can add or delete IP routes.
To Next Page
Loading...
