Section 3 – Web Configuration
LAN Interface
Choose SETUP > Local Network> LAN Interface. The page is shown as the
figure appears on the right. I
n this page, you can set the LAN IP address,
working mode, and MAC address control.
Step 1 In the IP Address textbox, enter the IP address of LAN interface. The
default IP address is 10.0.0.2
. The Router IP address is the URL
address for logging in the Web configuration page.
Step 2 Enter the subnet mask of LAN interface. I
f the Router IP address is
10.0.0.2, the range of subnet mask is set to 255.255.255.0.
Step 3 Select Secondary IP. Input a secondary IP address and subnet mask.
Secondary IP enables the secondary LAN IP address for your router.
It will be use
d when your primary router IP address is in the same
network segment with other LANs. T
he Secondary router IP address
must be in the different network segment from the primary one.
Step 4 Set IGMP Snooping. You can keep the default settings.
Step 5 Set the LAN Link Mode for each LAN port. It is recommended to keep
it as defaults.
To Next Page
Loading...
