Section 3 – Web Configuration
Broadcast SSID
Select whether the modem broadcasts SSID or not. You
can select Enable or Disable.
Select Enable, the SSID can be detected.
Select Disable
to hide SSID, the wireless clients
cannot find the SSID. You need to enter the SSID and
password of the wireless network manually.
Relay Blocking
Wireless isolation. Select Enable, the wireless clients that
are connected to the modem cannot intercommunication.
Ethernet to
Wireless Blocking
Whether the wireless network can communicate with the
Ethernet network or not.
Wifi Multicast to
Unicast
Enable it to using unicast to transmit multicast packet
After setting, click Apply Changes to save the settings.
Access Control
Choose ADVANCED >Advanced Wireless > Access Control. The page shown as
the figure appears on the right. If you choose Allowed Listed, only those clients
whose wireless MAC addresses are in the access control list will be able to connect
to your Access Point. When Deny Listed is selected, these wireless clients on the
list will not be able to connect the Access Point.
To Next Page
Loading...
